E-TON Viper 150 Spezifikationen PDF herunterladen (Seite 39)

6-2

Ambient temp./choke position

6. Completely close the throttle lever and start

the engine by pushing the start switch.

TIP

If the engine fails to start, release the start switch,

then push it again. Pause a few seconds before

the next attempt. Each cranking should be as short

as possible to preserve battery energy. Do not

1. Fully open “ON”

2. Half open (warming up position)

3. Closed “OFF”

4. Choke

0°

30°

10° 20° 30°

50° 70° 90°°F

°C

5. Use the choke in reference to the figure:

Position (1):

Cold engine start with ambient temperature be-

low 30 °C (90 °F).

Position (2):

Warming up position.

Position (3):

Cold engine start with ambient temperature

above 25 °C (80 °F).

TIP

This model is equipped with an ignition circuit cut-

off system. The engine can be started under the

following conditions.

The transmission is in neutral.

The clutch is disengaged with the transmission

in gear. However, it is recommended to shift into

neutral before starting the engine.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 117 118

Keine Kommentare

E-TON Viper 150 Spezifikationen Seite 39