E-TON Viper 150 Spezifikationen PDF herunterladen (Seite 83)

8-12

4. Insert the dipstick into the filler hole (without

screwing it in), and then remove it again to

check the oil level.

TIP

The engine oil should be between the minimum

and maximum level marks.

5. If the engine oil is at or below the minimum

level mark, add sufficient oil of the recom-

mended type to raise it to the correct level.

6. Insert the dipstick into the oil filler hole, and

then tighten the engine oil filler cap.

To change the engine oil

1. Place the ATV on a level surface.

2. Start the engine, warm it up for several min-

utes, and then turn it off.

3. Place an oil pan under the engine to collect

the used oil.

TIP

If the engine was started before checking the oil

level, be sure to warm up the engine sufficiently,

and then wait at least ten minutes until the oil set-

1. Engine oil ﬁller cap

2. Dipstick

tles for an accurate reading.

3. Remove the engine oil filler cap, and then

wipe the dipstick off with a clean rag.

1. Maximum level mark

2. Minimum level mark

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 117 118

Keine Kommentare

E-TON Viper 150 Spezifikationen Seite 83