E-TON Viper 150 Spezifikationen PDF herunterladen (Seite 84)

8-13

7. Add the specified amount of the recommend-

engine oil filler cap.

Tightening torque:

Engine oil drain bolt:

8 Nm (0.8m·kgf, 5.8 ft·lbf)

Recommended oil:

See page 10-2.

Oil quantity:

1.0 L (1.06 US qt) (0.88 Imp.qt)

NOTICE

Do not mix any chemical additives. Do

not use oils with a diesel specification

of "CD" or oils of a higher quality than

specified. In addition, do not use oils

labeled "ENERGY CONSERVING II" or

higher.

the crankcase.

8. Start the engine, and then let it idle for several

Make sure that no foreign material enters

minutes while checking it for oil leakage. If oil

is leaking, immediately turn the engine off and

check for the cause.

9. Turn the engine off, wait at least ten minutes,

and then check the oil level and correct it if

necessary.

4. Remove the engine oil filler cap, and then

remove the engine oil drain bolt to drain the

oil from the crankcase.

5. Check the washer for damage and replace it if

necessary.

6. Install the engine oil drain bolt, and then tighten

it to the specified torque.

1. Engine oil drain bolt

2. O-ring

3. Spring

4. Oil filter element

ed engine oil, and then install and tighten the

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 117 118

Keine Kommentare

E-TON Viper 150 Spezifikationen Seite 84